Nemesis 200R40 Barfighter build up parts list - NOW WITH POWERCART HOT LINKS!
BUY IT ALL IN ONE KIT HERE
Roller Group: * This package is also available in our roller section
Drive Group: * Assumes you have a motor already
No front brake was used for this build. If you would like to run a front unit you’ll need these additional parts:
Body Group:
Control Group:
Electrical Group:
See a preview of the finished product as it unfolds on REDBARRON TV!
SHOW SCHEDULE:
Pending show links below will become active as we post them. Be sure to check back often to see updates!
0) Introduction
1) Basic frame prep:
2) Installing Neck cups:
3) Tree & fork installation
4) Wheel & rim setup - spacer notes
5) Brakes & Kickstand
6) Motor install, chain & sprocket tips
7) Rear fender mockup
8) Fabbing the barfighter oil tank
9) Upper & lower controls
10) -- more posting soon...
What should I buy next?
Shown here is every part needed to build our classic BAR FIGHTER chopper based upon our NEMESIS 200R for SPORTSTER or BUELL motors.
We’ve broken it down into groups for you so you can build each system in sections as your budget allows.
Each part including a * is optional.
Motor Group: ANY TUBE FRAME BUELL or SOLID MOUNT PRE 2004 EVO YEARS SPORTSTER MOTOR- PLEASE NOTE: XB MODEL BUELLS WILL NOT WORK
BAR FIGHTER 200
by Red Barron
